Skip to content
  • News
  • Equipment
    • Aquarium Lighting
    • Fish Tank
    • Pumps
    • Skimmer
  • Livestock
    • Corals
    • Fishes
  • Reefer 170
  • Reefer 625XXL
  • DIY
  • News
  • Equipment
    • Aquarium Lighting
    • Fish Tank
    • Pumps
    • Skimmer
  • Livestock
    • Corals
    • Fishes
  • Reefer 170
  • Reefer 625XXL
  • DIY
  • Home
  • / Equipment /
  • News
  • /
  • Reefer 625XXL
  • /
  • Orphek Atlantik LED Replacement
Modern Reefer

Orphek Atlantik LED Replacement

In this video, I go through and show how the LEDs can be replaced on the Orphek Atlantik. I had an issue where a few of them were dead from each of the lights. I went ahead and planned out a night where I had time to go through and desolder the old LED and solder in new LEDs. I went through a step-by-step process to get the LEDs replaced. If you have any questions, feel free to drop them down in the comment section.

Temp settings on the Soldering iron: I have the temperature on the desolder and soldering iron set to 350 and then ramp it up to 400 because I needed the extra heat to break into the solder when I was desoldering the LED legs.

**Contact Orphek for the replacement LEDs here: contact@orphek.com

Make sure to send them a list of the ones you need with the nanometer spectrum value (420nm, 410nm, etc) If you need help identifying which ones you need, look at the Orphek link below. https://orphek.com/atlantik-v4-reef-a…

Tools Needed

  • Flat Screw Driver Kit
  • Soldering
  • De-soldering Tool
  • Soldering Flux
  • Heat Sink Paste

These are the most common LEDs that die out on the Orpheks. You can also get them below if Orphek does not have any available.

  • 400nm
  • 410nm
  • 420nm (425nm)
  • 430nm (425nm)
  • 460nm

The video shows the process in which the LEDs were replace.

 

I get a kickback if you use my Affiliate links. This really helps out with supporting the site to keep it alive. Thank you very much!

Tags: LED Replacement, Orphek Atlantik v4 Gen2

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Recent Comments

  • admin on Red Sea Reefer 350 Sump Hard piping setup
  • Ari on Red Sea Reefer 350 Sump Hard piping setup
  • Sambasivarao Ramisetti on Mars Aqua 300 watt LED modification
  • admin on Red Sea Reefer 350 Sump Hard piping setup
  • Glenn Ayer on Red Sea Reefer 350 Sump Hard piping setup

Recent Posts

  • Kessil a360a Repair (FixReef.com Review)
  • Hang-on-back (HOB) Protein Skimmer Comparison
  • Aperture Pet & Life is Growing
  • Most Popular Saltwater Mix
  • ITC Reefculture presents PARwise

Tags

2k Gyre 4k Gyre 24 volt AI Hydra 32HD AI Hydra 64HD AI Prime AI Prime 16HD AI Prime Fuge AI Prime SOL aquamaxx Aquarium controller Battery Backup calcium Coral Growth Ecotech Icecap Icecap Dual WiFi Controller Icecap Gyre Icecap K1-Nano Skimmer IM DC Skimmer Innovative Marine jet pump LED Lighting Lighting Control Linear flow Linear Pump magnesium Marco Aqua Skimmer Maxspect Nuvo Skimmer OR2 Light bar Orphek Atlantik v4 Gen2 orphek light setup Ph Meter Profilux pump reef Reef Octopus Blade Pump Reef Octopus NS-80 Reef Octopus Skimmer return pump RO NS-80 Version 2.0 WiFi

Kessil A360x Review

https://www.youtube.com/watch?v=sFW5feDi1N8&t=1s

Cloudy Tank

https://www.youtube.com/watch?v=Jl5EZAHKR7k&t=15s

Orphek Atlantic LED

https://www.youtube.com/watch?v=3oHhczYpHNg&t=2s

Custom Rock Scape

https://www.youtube.com/watch?v=6iqw_d6Mbyc&t=2s

Orphek Or2 Lightbar

https://www.youtube.com/watch?v=CWihkNaAUow&t=5s

Copyright 2019 | Theme by ThemeinProgress | Proudly powered by WordPress